Shopping Cart
no products

DRIFTWORKS Geomaster rear Race Hub Knuckles - Nissan 180SX 200SX 240SX S13 S14 S15

Product No.:
08070003120003
Shippingtime:
shipped within 2 weeks shipped within 2 weeks (abroad may vary)
    599,90 EUR
    incl. 20% tax excl. Shipping costs

     

    DRIF Geomaster rear Race Hub Knuckles - Nissan 180SX 200SX 240SX S13 S14 S15

    This is a custom made set of hubs (or knuckles) with completely different geometry settings from standard.
    You will receive a set of 4 Hub Knuckles with Polyurethane bushes already installed.
    Fitting the Driftworks Geo Master Knuckles lowers the car by 50mm rear without changing any other parts, keeping all the suspension arms at the correct geometry and keeping full suspension travel. This corrected roll centre means that lowering your car no longer ruins the 'in travel' alignment or overall feeling of the car. Handling benefits are night and day compared to your normal 'slammed' track car, specifically traction is notably improved over a traditionally lowered car.

    A simple way to overcome the old problem of the steering going over-centre when running with lots of steering lock. With aftermarket knuckles such as our own Geomaster Hub Knuckles this problem is further exaggerated! Normally, you would have to relocate your steering rack to overcome it and gain access to more steering lock, but now you can just buy bolt on parts!

    Because of the geometry changes on the hubs, the standard and aftermarket track rods are aproximately 20mm too short.. To solve this you can purchase the optional Driftworks Rack Spacers. Which also have the added benefit of changing the point that the steering goes 'over centre' therefore giving you even more steering lock. Alternatively you can make your own solution to solve the need for longer track rods or ends.

     

     

     

    This product is designed for Nissan 200sx/Silvia S14 and S15. Due to the drop given we recommend 18" wheels.

     

     

    It is possible to fit to an S13 with the information below:

     

     

    We cannot guarantee fitment with different brand coilover systems & suspension arms. We also recommend 18" wheels.

     

    Although it is a bolt on solution, it can limit other components, for instance you may find your coilover is not capable of going high enough. You may find you have clearance issues with tension rods due to the incredible amount of steering lock the hubs can acheive.

    Only a 5 stud wheel bearing will fit the front spindle. To fit them to an S13 you will need a 5 stud front wheel bearing from an S14 or S15 (only).
    To fit the fronts to an S13 you will also need to drill the holes out in the bottom bracket of your coilover to 14mm, and use 14mm bolts from an S14/15 with some washers, as the diameter of the hub where the coilover mounts is slightly slimmer on the S14. You will also need S14 fitment front lower arm balljoints.

    To fit the rears to an S13 and retain the drum handbrake, we have included the necessary holes in the back plate. Some brake components will need swapping from the left to the right side to work, and other minor modification may be required.
     

     

    Features :

    • Increases the overall suspension performance
    • Corrects the suspension geometry failure which occurs when lowering the car
    • Lowers the car by 45mm
    • Increases steering lock
    • High quality with hubs with polyurethan bushings


    Contents :

    2x Geomaster Hubs